By adding ____ tasks to your list, an item that requires attention will not be overlooked.

You are to set up Open Shortest Path First (OSPF) routing between all four routers in this network. All routers are to be assigned to area 0. The LAN addresses and subnet assignments for each network are provided in Table 1. You are required to create individual IP assignments for all devices in your network. Additionally, you are to configure the network according to the following specifications. Test your network carefully as you progress and verify that each task has been successfully completed.

Step 1. Prepare a list of IP addresses for each networking device in your network.



Step 2. You are to set the passwords for the console 0, vty 0 4, and enable secret to ciscopress

for each router.

Step 3. You are required to configure a Telnet connection to all routers.

Step 4. The VLAN1 IP address for SW1 should be set to 10.10.10.1.

Step 5. The default gateway address for SW1 should be set 10.10.10.250.

Step 6. The gateway of last resort on all routers should be set to R4’s Fa0/1 IP address.

Step 7. Create OSPF routing for the routers on the network. Use a process ID of 100 and use

area 0 for the backbone.

Step 8. Configure an access list that prevents any pings or Telnet connections to PC1 from any

host in the 10.10.30.0 or 10.10.40.0 network going to the 10.10.10.0 network.

Step 9. Be sure to save your configuration. You will be asked to demonstrate your network to

receive your

What is the primary difference between an imported table and a linked table?

What will be an ideal response?