What are the steps taken by WDS when deploying an image?
What will be an ideal response?
When deploying an image by using WDS, the following process is used:
1. Enable PXE in the client computer and configure it to boot from network first.
2. Reboot the workstation and press F12 to perform a PXE boot.
3. The workstation obtains an IP address from a DHCP server and contacts the WDS server.
4. Select a PXE boot image if required. You may create additional boot images to support network drivers not available in the default Windows PE configuration.
5. The boot image is downloaded to a RAM disk on the client computer and Windows PE is booted.
6. Select an install image to deploy from the menu.
7. The install image is copied to the computer.
You might also like to view...
Match the following terms about how computers operate with their definitions:
I. Binary II. Bit III. Byte IV. Cache memory V. Gigahertz A. A binary representation of one character that contains eight bits B. A two-state system in which circuits must be either "on" or "off" C. A measurement used to represent processor speed D. A unit in the binary system that has two possible values: 0 or 1 E. Temporary storage located close to the CPU
You can pull one or more slices away from the pie to distinguish them, creating what is called a(n) ____________________ pie chart.
Fill in the blank(s) with the appropriate word(s).